Satec PM175 Manual User Manual download pdf (Page 59)

Chapter 4 PAS Application Software

Setting up Communications

Series PM175 Powermeters

2. In the “Protocol” box, select the same communications

protocol as you have in your meter. The default protocol

setting in your meter for all ports is Modbus RTU.

For more information on configuring the protocol parameters,

refer to the “PAS Getting Started” guide.

Communicating through a Dial-up

Modem

Configuring a Modem

1. On the Connection tab, select a local modem installed on

your PC.

2. Click on Phones to add the phone number of the remote

meter to the phone list.

3. Type the phone number in the “Phone number” box, add

comments if you desire, click Add, and then click OK.

4. From the “Phone number” box on the Connection tab,

select the phone number from the list, and then click OK.

Selecting the Communications Protocol

On the Connection tab, click Protocol, and then select the

protocol settings as shown above for a serial port.

Communicating through the Internet

If you are communicating through the Ethernet port, you

should define the IP address of your meter on the network.

1. On the Instrument Setup tab, select Internet Site.

2. Click on the Connection tab.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 167 168

No comments

Satec PM175 Manual User Manual Page 59